Setup default A password is required to access the Setup Utility only. However, this f unction is strongly recommended not to use. System will boot-up to DOS prompt. The rest of this manual is intended to guide you through the process of configuring your system using Setup. Pull the socket locking lever out from the socket and then raise the lever up to a degree angle.

Uploader: Kir
Date Added: 20 August 2009
File Size: 22.67 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 67405
Price: Free* [*Free Regsitration Required]

Table of Contents Chapter 1: Auto default2,3,4,5,6. Power on the system again. When connecting with wires onto c onnectors, please note that the red wire is the positi ve and s houl d be connected to pi n 2, and the bl ac k wire is Ground and s hould be c onnected to GND.

System does not boot from hard disk 1. Transfer da nych do 3. The system time is shortened if you disable the function, but system will need AGP driver to initialize the card.

Connect the fan cable to the connector while matching the black wire to pin 1. Enabled for Windows XP and Linux 2. In this panel, you can get model name and detail information in hints of all aueio chipset that are related to overclocking.


Enabled enable the function. Make sure power cable is No power to the system at all securely plugged in.

Click on each device driver to launch the installation program. Enabled defaultDisabled Swap Floppy Drive For systems with two floppy drives, this option allows you to swap logical drive assignments. Enabled Virus protection is activated. Enabled defaultDisabled USB 2.

Biostar P-A7B Motherboard drivers for Windows | download laptop drivers

954p-a7b Define Allow you to set each mode individually. All hard disks are capable of breaking down at any time. The BIOS has been recovered and will work properly. Loose parts will cause short circuits which may damage the equipment. Let user select a restoring way if system need to do a fail-safe reboot. Make a bootable floppy disk. Remove the power cord from power supply for seconds. T his equipment generatesuses and can radiate radio frequency energy and, if not ins talled and used in accordance with the instructionsmay cause harmful interference to radio communications.

Be fore you start installing the mothe rboard, please make sure you follow the instructions be low: All the CMOS data will be loaded as defaults setting. Ref ormat the hard driv e.


Modes 0 to 4 will increase performance progressively. Backing up the hard drive is extremely important.

Download Realtek High Definition Audio Driver

Disabled default disable the function. Voltage Panel Click the Voltage button biistar Main Panel, the button will be highlighted and the Voltage Panel will slide biotar to up as the following figure. With the Overclock Manager, users can easily adjust the frequency they prefer or they can get the best CPU performance with just one click.

Check cable running from disk to disk controller board. Hard disk can be read and applications can be used but booting from hard disk 2.

In this case, please double check: Keyboard lights Using even pressure on both ends of are on, power indicator lights are lit, the DIMM, press down firmly until the and hard driv e is spinning.